:	Oct 13, 2004

.

Disconnect the battery ground cable.

.

Make the SRS system safe.

.

Remove the instrument panel driver side reinforcement.

.

Remove the instrument panel passenger side reinforcement.

.

Remove the instrument panel speaker.

.

Remove both A-pillar upper trim panels.

.

Remove the sunload sensor.   Release the 2 clips.   Disconnect the electrical connector.

.

Release the passenger air bag module bracket.   Remove the 2 Torx screws.

.

Disconnect the 3 electrical connectors from the passenger air bag module.

.

:   Avoid dropping the screw inside the instrument panel. Remove 1 Torx screw and 1 bolt, from the instrument panel upper section speaker aperture.

.

Release the instrument panel wiring harness.   Release the 2 clips.

.

With assistance, remove the instrument panel upper section.   Remove the 5 Torx screws.

.

:   Do not disassemble further if the component is removed for access only. Remove the passenger air bag module.   Remove the 4 nuts.

.

Remove the windshield defroster duct.   Remove the 7 screws.

.

Install the windshield defroster duct.   Tighten the screws.

.

Install the passenger air bag module.   Tighten the nuts to 10 Nm (7 lb.ft).

.

With assistance, install the instrument panel upper section.   Tighten the screws.   Attach the wiring harness.

.

Tighten the instrument panel upper section speaker aperture bolt to 10 Nm (7 lb.ft).

.

Secure the passenger air bag module bracket.   Tighten the Torx screws to 25 Nm (18 lb.ft).

.

Connect the passenger air bag module electrical connectors.

.

Install the sunload sensor.   Connect the electrical connector.   Secure with the clips.

.

Install the A-pillar trim panels.

.

Install the speaker

.

Install the instrument panel passenger side reinforcement.

.

Install the instrument panel driver side reinforcement.

.

Connect the battery ground cable.